rhikdavis

Originally Posted by PennsyPride

.................................................. ...............A|______________________________|B. ....................... C|_____________________
_________________________________________/________________________________\_________________/_______________________D


At A,B and C you want to electrically isolate the track from the main. This can be done by using insulated joiners or physically cutting a gap in the rail and inserting some plastic

...

Originally Posted by WP&P

I'm sure you'll hear from some DCC enthusiasts that it will probably be simpler overall to go that route; you just feed power to the rails, without worrying about switching certain segments on or off. You can get a decent starter DCC controller and engines with decoders already installed, so as far as setup goes the only extra step might be programming (i.e. configuring the controller to recognize the engine).

I'm not a DCC guy; I'm Old Skool, using toggle switches to assign discrete

...

https://photos.google.com/share/AF1Q...M0Nm9hVzRPZlFB