View RSS Feed

Recent Blogs Posts

Anything relating to 'N' Scale.

  1. First real run

    OK, so I've been inconsistently working on my track the last few weeks. Cleaning has been a problem/chore, and I've tried a lot of different solutions. I tend to like the Woodland Scenics solution a lot, but the inserts are pricey. Because my track was so dirty to start, I've been using the wand and the two hard cleaners, and then using paper towels for the soft stuff since I've ruined the included soft inserts. After a few weeks of elbow grease (not total, but like clean, test, clean some more, ...
    Tags: cleaning, metra, track Add / Edit Tags
    Categories
    'N' Scale Related
  2. Wiring Woes

    So, I've been hacking away at a running layout the last two weeks. Frustrating, but got it done. I don't love how I did the wiring installation, wires tend to go everywhere. I have a spoke and wheel setup, which isn't conducive to clean wiring that I have yet to discover. Each hub is a 6 point distribution block out to the feeders and the point motors. Since each hub is roughly in the middle of it's area, there are wires everywhere. If I keep thinking about it, I might get to a way to make this ...
    Tags: dcc, wiring Add / Edit Tags
    Categories
    'N' Scale Related
  3. More micro controller work

    So, a while back, I found a guy on Ebay in China who made n scale traffic signals for road traffic. The assemblies themselves are very nice, and everything I have purchased so far just works.

    https://www.ebay.com/usr/wehonest_us

    So, I decided to control them with a micro so I could make it act like a US traffic intersection. The video included shows the results. Works like a charm. For this, I used an Adafruit Raspberry Pi Pico in the feather form factor, and created a ...
  4. Wholesale layout changes

    So, as I've been going on, I have realized the original design did allow for reversing, but it took some work and didn't allow to continuous run anything. So, I'm ripping up a lot of the layout to fix that. I've got a new design, including a new Anyrail file to show what I've changed. At a minimum, the two reversible loops (orange/yellow) are now able to be used as a larger continuous run. The trick will be to use block detection so that when a train enters one of the loops, the turnouts are triggered ...
    Categories
    'N' Scale Related
    Attached Thumbnails Attached Files
  5. Learning that gluing things down doesn't mean that it's done

    I've spent the last few days ripping up old track and doing some cleanup and fixing. I wasn't happy with how some of the elevation transitions worked, and so I kinda gave up and just started over on a whole section of track. You can see the progress in the new images, but the rise into the upper loop was ripped out to make it cleaner and more even. In the past, there were too many elevation changes, and the way I put the turnouts in, there were some uneven transitions, including one under a turnout. ...
Page 1 of 43 1234511 ... LastLast